If your Cino F780BT is no longer connecting to it’s Smart Cradle, you might need to re-pair them.
1. Set the Scanner and Smart Cradle into the Uninstall state.
a. To put the scanner in the Uninstall state, scan the barcode below (this can also be found in the attached pdf):
Failing this, take a paper clip and press the Scanner Reset Button.
b. To set the Smart Cradle into the Uninstall state, press and hold the reset button for over 3 seconds until the LED indicator begines to display alternate red and green blinks.
2. To pair, scan the barcode below (this can also be found in the attached pdf) and then place the scanner on the smart cradle.
Please refer to the below LED patterns for further troubleshooting:
Cino BT Scanner:
– 1 blue blink per 2.5 seconds: Radio connected
– Alternate red and green blinks: Uninstall state
Smart Cradle:
– Center – Steady blue; side – steady green: Radio connected
– Centre – off; side – steady red: Radio disconnected
– Alternate red and green blinks: Uninstall state